A Quick Overlook of Deadbolts – Your Cheatsheet

How You Can Install a Deadbolt to Your Door Rather than trusting the security of your home with the spring-loaded door knob, the deadbolts offers enhanced security. A key has to be used to open a deadbolt from any side. If you have the objective of installing a deadbolt to your home; it is quite easy. Most of the manufacturers have a template instruction you on how to install it. To get a clear picture of installing a deadbolt, read this article. Read on the manufacturer’s template first. It features reference points that will be marked on the door using an awl. This position should not be less than six inches above the door knob What follows is drilling in the hole for the deadbolt. The holes are to be made to the points marked according to the manufacturer’s template. A hole saw needs to be applied here.To avoid splinters, finish the hole from the other side of the door. Of your hole saw is not big enough to go through the breadth of the door use a standard bit to drill.
Interesting Research on Deadbolts – Things You Probably Never Knew
Drilling a hole through the edge of the door is the third step. You need to use 11/2″ spade bit drill. Go on to mortise the area around the faceplate. Use a wood chisel to make sure that it flushes with the door. A smaller chisel might be required to mortise the rounded corners.
The 10 Best Resources For Deadbolts
Move on to fasten the bolt to the door. Mortising will be required until the faceplate fits right. Make the pilot holes and fasten the deadbolt to the door with screws. Installing of the cylinder and the thumb level follows. You start by installing the exterior and make sure that the writings are upright. Continue to work on the interior and tighten the screws where the mounting holes should be inside the lock. Fastening of the deadbolt should be done suing screws. With paint or lipstick, mark the tip of the bolt. Shut the door and by severally turning the bolt, maker the door frame. The 7/8″ spade bit should be applied to drill two holes in the door frame for the deadbolt. Polish the space surrounding the holes such that the strike bolt will be flush with the door frame. Fasten the bolts using screws on the holes made. This done, your home will be under higher security than it would be on a standard spring loaded door knob.In case you feel that the procedure is somehow complex for you, you beer seek an expert to do it for you. There are possibilities of doing mistakes when you do it yourself and they can be costly. Such a mistake can mean that you deface your door with ugly marks which you won’t likeKeeping an eye on the manufacturer’s template and the guide to help you get it right.